gcloud compute target-pools set-backup - set a backup pool for a target pool
gcloud compute target-pools set-backup NAME (--backup-pool=BACKUP_POOL | --no-backup-pool) [--failover-ratio=FAILOVER_RATIO] [--region=REGION] [GCLOUD_WIDE_FLAG ...]
gcloud compute target-pools set-backup is used to set a backup target pool for a primary target pool, which defines the fallback behavior of the primary pool. If the ratio of the healthy instances in the primary pool is at or below the specified --failover-ratio value, then traffic arriving at the load-balanced IP address will be directed to the backup pool.
To cause TARGET-POOL (in region us-central1) to fail over to BACKUP-POOL when more than half of the TARGET-POOL instances are unhealthy, run:
$ gcloud compute target-pools set-backup TARGET-POOL \ --backup-pool=BACKUP-POOL --failover-ratio=0.5 \ --region=us-central1
To remove BACKUP-POOL as a backup to TARGET-POOL, run:
$ gcloud compute target-pools set-backup TARGET-POOL \ --backup-pool='' --region=us-central1
- NAME
The name of the target pool for which to set the backup pool.
- Exactly one of these must be specified:
- --backup-pool=BACKUP_POOL
Name of the target pool that will serve as backup.
- --no-backup-pool
Unsets the backup pool. This disables failover.
- --failover-ratio=FAILOVER_RATIO
The new failover ratio value for the target pool. This must be a float in the range of [0, 1].
- --region=REGION
Region of the target pool to set a backup pool for. If not specified, you might be prompted to select a region (interactive mode only).
To avoid prompting when this flag is omitted, you can set the compute/region property:
$ gcloud config set compute/region REGION
A list of regions can be fetched by running:
$ gcloud compute regions list
To unset the property, run:
$ gcloud config unset compute/region
Alternatively, the region can be stored in the environment variable CLOUDSDK_COMPUTE_REGION.
These flags are available to all commands: --access-token-file, --account, --billing-project, --configuration, --flags-file, --flatten, --format, --help, --impersonate-service-account, --log-http, --project, --quiet, --trace-token, --user-output-enabled, --verbosity.
Run $ gcloud help for details.
These variants are also available:
$ gcloud alpha compute target-pools set-backup
$ gcloud beta compute target-pools set-backup